800 ml. refill cartridge
dispenses up to 1000 hand
washes (supplied).
1600 ml. refill cartridge
dispenses up to 2000 hand
washes.
When using a 1600 ml. refill
cartridge, the dipswitch
(located on the Motor behind the black grommet just above the Reset
Button) must be in the Down Position.
4 - Connect AC Power (Models ESD-200 & ESD-300 Only)
5 - Install Soap Cartridge
A
Connect the power cord from the
transformer by inserting then
screwing clockwise into inlet on top
of motor assembly.
Note: Transformer
supplied with 24”
(610 mm) cord.
Operation
A
Unlock pump on
refill cartridge by
twisting counter-
clockwise. Actuator
will pop-up.
B
Guide refill tube up through
bottom of motor assembly.
B
Plug transformer into 120 VAC
wall receptacle, activating the
soap dispenser.
C
Wall clip set may be
used to hold the
power cord against
the wall.
Important: DO NOT handle soap refill cartridge by tube. For proper
operation, ensure that tubing is not loose or bent.
D
Press the refill reset button.
This will automatically
prime the soap refill bottle
and initiate the counting
mechanism.
RESET
BUTTON
As the user’s hands enter the beam’s effective range, the beam is reflected
back into the sensor receiver and activates the solenoid valve allowing a
single soap application to flow from the spout.
• Flashing RED light in the sensor window indicates low refill.
• Flashing YELLOW light in the sensor window indicates low battery
(Models ESD-250 & ESD-350 only).
C
Lock soap refill into
place by turning
clockwise ¼ turn.
5
TRANSFORMER POWER CORD
MOTOR ASSEMBLY
CORD
CARE AND CLEANING OF...
...THE SOAP DISPENSER
Deactivate the soap dispenser by placing
your fingers or thumb over the sensor area
while you clean. The sensors are located in
the upper right and upper left corners of the
activation zone.
Once dispenser is cleaned, remove fingers
or thumb from the sensor area.
...CHROME AND SPECIAL FINISHES
DO NOT use abrasive or chemical cleaners
(including chlorine bleach) to clean Spout that may
dull the luster and attack the chrome or special
decorative finishes. Use ONLY mild soap and water,
then wipe dry with clean cloth or towel.
While cleaning the bathroom tile, protect the Spout
from any splattering of cleaner. Acids and cleaning
fluids will discolor or remove chrome plating.
