{ Design. Uniqueness. Innovation }
INNOVATION
DIRECT
SERIES
7
8
4.3 Unit mount
Angle bracket mount
1) Take the angle bracket from the kit and situate it 150-160 cm from the floor line.
2) Mark and drill two halls in the wall.
3) Take two nuts from the kit and hammer them into the drilled halls.
4) Fix the angle bracket on the wall by the screws from the kit.
5) Then fix surface mount bracket over the angle bracket by two bolts from the kit.
6) Connect all communication wires and fix the door station on the surface mount bracket by one bolt from
the bottom side.
Surface mount
1) Take the surface mount bracket from the kit and situate it 150-160 cm from the floor line.
2) Mark and drill four halls in the wall.
3) Take four nuts from the kit and hammer them into the drilled halls.
4) Fix surface mount bracket on the wall by four screws from the kit.
5) Connect all communication wires and fix the door station on the surface mount bracket by one bolt from
the bottom side.
5. Software
5.1 Wired network connection steps
Use twisted pair CAT5 or CAT6 cable to connect ML-20IP video door station to the local network according
to the diagram on page 5.
Wired network setup includes next steps:
1) Enter «GooglePlay» (for Android) or «AppStore» (for iOS) and search for «Slinex» application, then install
this applicationи on your mobile device.
2) Connect mobile device into the local network, which is video door station connected.
3) Run «Slinex» application on your mobile device and push icon to add a new device.
4) Push «Click here for connected wired/wireless device» button, then push «LAN search» button.
5) When new device have been found, choose its number in the list and fill in the device information:
Name: enter device name in the list
UID: unique identification number of the device
User:
Admin
(by default)
Password:
888888
(by default)
then push «Confirm» button.
6) Device will be added to the bar in the middle part of the screen. You can also push alarm notification on
or off by the blue switch in the devices list («Switch ON/OFF notification»).
7) If you want to view the image from the door station press its icon on the bar and then press first channel
icon to start monitoring mode. Press first channel icon again to stop monitoring mode.
