6 of 44
ISSUED: 12-02-09 SHEET #: 202-9418-1
Installing Adapter Brackets
=* / $$ > $Y> / $**$ $
the screen. Place screen face side down. If screen has knobs on the back, remove them to allow the
adapter brackets to be attached. Place adapter brackets (
B
) on back of screen, align to holes, and
center on back of screen as shown below. Attach the adapter brackets to the back of the screen using
the appropriate combination of screws, washers, and spacers as shown in steps 2-1 or 2-2.
NOTE:
Top and bottom holes of screen must always be used.
Verify that all holes are properly aligned, and then tighten screws using allen wrench (
L
).
2
X
X
B
CENTER BRACKETS
VERTICALLY
ON BACK OF
SCREEN
NOTE:
"X" dimensions should be equal.
NOTE:
For
proceed to step 2-1. For
bump-out or recessed back screen
skip to
step 2-2.
