PRESSURE RELEASE
The PRESSURE RELEASE ensures optimum PSI pressure. Push the area to
deflate the tire if it has been overinflated, or if there is too much air prior
to inflation. Check your gauge for the desired PSI level. NOTE: Correct
tire pressure can be found in your vehicle’s owner’s manual or driver side
doorjamb.
SEALANT CARTRIDGE REMOVAL INSTRUCTIONS:
Unwrap
air/sealant hose.
Pull cartridge out
horizontally.
Lift off cartridge
cover.
Rotate cartridge
to upright position.
FLAT TIRE REPAIR (AIR + SEALANT) INSTRUCTIONS:
Check your tire warranty prior to installation of this product.
NOTE: Seals punctures up to 1/4in. (6mm) in tread area for flat tire repair.
Correct tire pressure can be found in your vehicle’s owner’s manual or driver side doorjamb.
Screw air/sealant hose onto tire’s valve stem.
Select AIR + SEALANT.
NOTE: Lay Flat Tire Repair Kit on the ground facing
upward.
Plug inflator into 12 volt accessory power outlet. Do not run vehicle while
inflator is operating. You may need to be in “accessory” or “on” position.
Please make sure emergency brake is set and car is in park.
Push green button to turn system on. Gauge pressure will initially be
high until the sealant bottle is emptied. Once bottle is empty the gauge
pressure will drop and tire inflation begins. Fill to desired pressure. Turn
system off and check tire pressure. Once correct tire pressure has been
achieved, disconnect air hose and power plug.
1
2
3
4
Drive two miles with speeds less than 25 miles per hour to disperse sealant throughout the tire,
allowing it to seek out and seal the puncture. Recheck tire pressure to verify that the puncture has
been sealed.
At your earliest opportunity take your vehicle to a tire repair facility for a permanent professional
repair. Inform tire repair specialist that Slime Sealant is in the tire.
1
2
3
4