CAUTION: HOT • DO NOT HOLD IN HAND WHILE OPERATING • PLACE INFLATOR ON A HARD,
CLEAN SURFACE.
1. DO NOT run vehicle while inflator is operating. You may need to be in “accessory”
or “on” position. Please make sure emergency brake is set and car is in park. Always
ensure the valve connector is fully seated to depress the core of the valve stem for
proper inflation.
2. DO NOT use inflator continuously for more than 15 minutes. Allow unit to cool
approximately 25 minutes between uses. Do not leave inflator unattended.
3. ALWAYS use a pressure gauge to check tire pressure. DO NOT overinflate.
4. Soft inflatables (i.e. rafts, balls, etc.) may not have recommended pressure markings.
Be careful not to inflate items beyond their capacity.
5. While operating, never block the inflator input or output.
6. Keep inflator out of reach of children.
7. For use with 12 volt DC power outlets rated 15 amps or higher. Do not use with older
8 amp cigarette lighter receptacles.
IMPORTANT!
When using the supplied inflatable adapters, the valve
depressor adapter (Fig. X) must be used in conjunction with the inflatable
adapters. Failure to use the supplied valve depressor adapter with inflatable
adapters will result in over-pressurization and failure of the Flat Tire Repair
Kit. To install, remove the valve depressor adapter assembly from the back
of the Flat Tire Repair Kit. Unscrew the Presta valve adapter and set aside.
Thread the valve depressor adapter into the air hose of the Flat Tire Repair Kit
(Fig. Y) until fully seated. Thread on the desired inflatable adapter until snug
and inflate item.
Fig. X
Fig. Y
AIR ONLY INSTRUCTIONS:
Check your tire warranty prior to installation of this product.
The AIR ONLY mode can also be used for bicycles, sports balls, rafts and other inflatables.
Screw air/sealant hose onto tire’s valve stem.
Select AIR ONLY.
NOTE: Lay Flat Tire Repair Kit on the ground facing
upward.
Plug inflator into 12 volt accessory power outlet. Do not run vehicle
while inflator is operating. You may need to be in “accessory” or “on”
position. Please make sure emergency brake is set and car is in park.
Push green button to turn system on. Fill to desired pressure. Turn
system off and check tire pressure. Once correct tire pressure has been
achieved, disconnect air hose and power plug.
1
2
3
4