The power cord extension is then installed into the mount bracket with two
M3x8mm flat head
screws
. Once the power cord has the bracket attached and power cable is routed through the
grommet. It may be attached to the case frame via two
M3x5mm flat head screws
at any of the
viable mount locations.
The bracket can be positioned to where it least obstructs the motherboard or GPU ports.
Make sure to point the open end of the inlet towards the rear of the case!
The SV540 includes an internal power cord
extension, protective grommet, and mount
bracket for routing the power supply inlet into
the"cable cubby" of the case frame.
Then clip the
Cable Grommet
onto the power
cord, before you install it into the case, then run
the cord through the cutout located above the
PCIe card tab cutout, and finally slide the grommet
into position as shown below.
POWER CORD
