Sleipner SE-IP120, Руководство по установке, Страница: 16 / 28

16
2685 13 2021
-
SE IP 80 & SE IP 120
Motor Installation
1. Install the motor onto the motor bracket ensuring the couplings are engaged together correctly (top and bottom). (NB: The motor can be placed
in all directions on the motor bracket. However, ensure the cable terminals are accessible for electrical installation later.)
2. If you are installing the motor at an angle of more than 30 degrees off vertical, the motor will require separate/ additional support. (NB: Do not
position supports on the motors top cap.)
3. Fasten the bolts holding the motor to the motor bracket with the above torque.
4. Check the drive shafts are engaged by rotating the propeller. (NB: Rotating the propellers can be hard due to the gear reduction and the motor,
however the propeller must be able to rotate via hand power.)
MC_0019
! Please refer to the graphic for special considerations relating to your model !
IMPORTANT
The thruster motor assembly must be protected using suitable covering to avoid dust/debris ingress from fabrication/maintenance/shipbuilding
operations. On completion of operations, the cover must be removed before operating the thruster.
MG_0073
1
2
3
FASTEN
(33 Nm)
(24 lb/ft)
Motor support
> 30°
Holding Key
IMPORTANT
Ensure the holding key
and coupling are
aligned when fitted
MG_0020
Thruster
Motor
Battery
12V or
24V
Fuse
Main
Switch
Nut
Tighten to
18Nm/ 13.8lb/ft
Washers
Isolation Cap
Lugs
+ +
- -
IMPORTANT
Do NOT use washers between lugs, this causes overheating
and fire. Spring washers must be placed in the outer
position before tightening the nut.
Hold in place for
securing the end nut.
Multi-lug configuration
Ensure lug faces are
back to back.
Spring
Washer
Nut
Nut
Lugs