SLEIPNER MOTOR AS SXP35POD, Руководство по установке

Страница: 10 / 24

10
6399 12 2022
-
HydroPOD 35 & 50
MG_0314
All rings need
+10% compression
+10%
compression
Hull
Mark and drill the remaining Hydropod holes.
(1 rear, 2 front)
Support
brace
MS
Polymer
Fasten
MS
Polymer
1
3
2
4
5
6
compression with
support segments
Hull
support
segment
Hydropod Installation
1. Temporally fasten the Hydro pod to the hull using the SX thruster bolts. Mark the remaining Hydro pod holes (1 rear, 2 front) and drill holes.
Clean the area from dust for installation of the thruster. (NB: Tightening the Hydro pod can reduce the gap between the mould and the hull from
compression. Note this when if required to add MS Polymer to fi ll gaps.)
2. Make support segments based on the hull profi le for the bolt and tube fasteners.
3. Check the length of the compression rings. Compression rings must be longer than hull thickness to allow for compression (NB: Cut compression
sealants to length top achieve 15% compression.)
4. Apply a sealant (MS Polymer) to: IF: required to fi ll gaps between the Hydro pod and the hull use an
- the inside surface of the cut-out holes on the hull. appropriate amount on the Hydro pod mould to achieve this.
-To the surface of the washer to the thread and
- in the recess of the main tube to the thread.
- 1cm deep inside all compression ring.
place all compression rings to bolt threads.
(NB: Ensure ample sealant (MS Polymer) around the bolts and centre tube for a watertight fi tting.)
5. Place the Hydro pod to the hull without the nose cap. Fasten the Hydro pod via the SX thruster and back hydro pod securing bolt. (NB: Wipe away
MS Polymer that has been pushed out from the compression of the Hydro pod to the hull.)
6. Place the Hydro pod nose cap and fasten nose cap securing bolt
MC_0269
! Please refer to the graphic for special considerations relating to your model !
For installations in high corrosive environments (saltwater) the exposed aluminium parts of the thruster must be coated with an epoxy primer
before antifouling or/and use.