Control Panel 86-08955
version 1.0 - 2014
4
Installation
Installation:
Find a comfortable position for the panel where it does not obstruct or are
obstructed by other controls. Use the enclosed cut-out pattern to mark the
area. Cut out the circular area as shown on pattern.
If the front surface around your cut out is jaggered or chipped, use a sealant
to assist the gasket.
A Put the gasket (2) in its designated track in the back face of the panel (1).
B Connect the contact with the control cable from the windlass .
C Connect the control output to the Sidepower automatic main switch if
installed.
D Put the panel (1) in place and screw in and tighten the four screws (3).
E Gently twist on the decor-/front ring (4) clockwise.
NB ! If the windlass runs the opposite way of the panel, swap positions of
the grey and the blue control cables in one contact, by the control box unit.
EN
