SLEEPTRACKER TEMPUR-Ergo Smart Base, Руководство по установке

Страница: 7 / 54

12 13
Plug the loose battery backup module
into the extra lead on the sync cable.
Remove the tie from the bundled power
supply cable (attached to the activated
carbon pouch near the head of the
base). Remove and discard all carbon
pouches. Then connect the two power
supply cables to the two power supplies
from the electronics bag.
Using the other end of the sync cable
you just plugged in,
repeat steps 7 – 9
on the opposite base.
Put the bases up on their legs.
STEP
9
STEP
11
STEP
10
STEP
12
CONNECT THE POWER SUPPLIES
• Two people are required.
Install the connector strips at both the
head and foot ends of the base.
• Slightly loosen the adjacent legs
on both bases to allow the strip to
fit between the leg and the frame.
Slide the connecting strip onto the
leg bolts, then secure the strip by
shifting it to the left. Re-tighten legs,
but do not overtighten. The bases
should be touching.
Plug both power supplies into a surge
protector (not included) connected to a
power source. The LEDs under the bed
will blink.
STEP
13
STEP
14
STEP
15
Using the remote, move the heads
of both bases into their full upright
position.
STEP
16
PLACE THE SLEEPTRACKER SENSORS
Install mattress retainer bars: slide the left
side of the bar into the bracket, then pull
the retainer bar over the opposite bracket
and insert the right side of the bar into the
opening.