Remove by placing index fingers over the wheels and pulling downward
and forward, at a 45 degree angle. Use sharp scissors to excise any ex-
cess material adjacent to areas of teeth impression. If the plastic is too
hard, then dip the edges in hot water for 10 seconds and try again. Place
back in the mouth. It should have a firm grip on your teeth.
Remove and replace 5 times and
then let set in place for two
minutes. During this time, pour
out the bowl of water and replace
with boiling water.
Lower Device
Pour the second bag of beads into the boiling water and stir with a fork.
Remove when they turn clear. Roll in hands into cigar shape. Place on a
non stick surface.
Drop the lower in the water. Remove
after 10 sec. Place the soft plastic
that you just rolled into the groove of
the lower mouthpiece. It is located
on the under surface of the device.
Remove Upper and Trim
On and Off 5 times
Beads in hot water
Lower in hot water 10 sec
