SLE 2000 HFO, Руководство по обслуживанию

Страница: 29 / 258

Issue 10 (01/10/2004) Page 29 of 258
• Lift up lever (A) on side of ventilator and
lower side flap.
• Remove the silencer (B) by pulling it
through the hole at the rear.
• Remove the exhalation block (C) by firstly
taking hold of the block and then pulling it
out towards you without the need for undue
force.
Refitting the silencer and exhalation block is the reversal of removal. Do not force the
exhalation block into place.
4.2.1 Cleaning, Disinfection & Sterilization chart
Table 1
Warnings (General): Do not insert any object (such as a needle) in to the gas ports. This
action will result in damage to the port. If the user believes there is a foreign object in a
gas port, please refer the ventilator to qualified service personnel for inspection and
repair.
Note: The silencer should be autoclaved only. If the silencer is found to have visual
contamination internally, discard and replace with a new silencer.
4.3 Cleaning method
Note: Cleaning is an essential prerequisite to disinfection and sterilization.
Ventilator. For cleaning use three clean, disposable, absorbent, non-shedding cloths. Wipe
clean with the first cloth using a hand hot water/mild general purpose detergent solution (as
prescribed by the appropriate hospital authority). Do not overload the cloth with liquid. Remove
the water/mild general purpose detergent solution with the second cloth using water only. Do
not overload the cloth with liquid. Wipe dry with the remaining cloth. Care should be taken to
ensure that the ventilator gas jets in the ports are not blocked by any debris.
Exhalation block. The exhalation block can be immersed and agitated in the detergent
solution. Do not insert any objects into the exhalation block. Rinse the exhalation block in clean
water, it must be allowed to dry thoroughly before sterilization.
Item Clean Disinfect Sterilize
Ventilator Yes Yes
Silencer Yes
Exhalation block Yes Yes Yes
A
B
C