SL Fernlicht StVZO, Руководство по сборке

Страница: 14 / 17

Engli
sh
26
SL AF StVZO
27
SL AF StVZO
Product Care, Storage and Charging
Product Care and Storage
Light:
After use in dirty areas clean the lamp and the cables externally with warm water and some mild
detergent.
Important!
Because of the delicate sealings, we do not recommend to open the lamp.
A leakage in consequence of opening the light is excluded from warranty! Before you try to repair
something on your own get in touch with our helpful Service Team.
Battery:
If you intend not to use the lamp for a longer period of time, fully charge and store it at a cold and dry
place.
Charging batteries:
1. Plug the included Wiesel charger into an outlet
2. Connect the charger to the battery, charging starts automatically the LED turns red
3. When the battery is fully charged the LED on charger turns green

Warning! This charger is to be used to charge rechargeable Li-Ion batteries only.
It is NOT suitable for charging NiMH batteries!
 Do NOT use non-rechargeable batteries. – Risk of explosion!

This charger may be opened ONLY by the manufacturer!
Troubleshooting
Problem
The light does not come on
and the power LEDs do not
flash when the battery is
plugged into the lamp.
With the battery plugged in,
the power LEDs do not come
on, but the PCS LEDs flash.
The runtime is too short.
Even after charging only
the 20% LED will light up
at the Smartcore battery.
The sensor does not respond
.
Cause
 Extremely discharged battery
 Battery not plugged into the
light or not plugged in
properly
 Faulty LED unit
 Discharged or old battery
 Old battery
 Low ambient temperature
 Faulty charger
 Unsuitable battery
 The indicator was reseted
 The sensor is not exposed
Solution

Charge the battery
 Check all plug contacts
 LED units needs replacement
 Get in touch with Lupine
 Charge battery
 Replace battery
 Keep battery warm
 Replace charger
 Use original Lupine battery
 Discharge the battery with
your light and fully charge it
afterwards
 Make sure the sensor is free
from any dirt
The lamp does not recognize
the transmitter.
 Lamphead and transmitter
are not linked.
 See chapter operation
remote control.

Button cell empty or wrong
side up.