ASSEMBLY
• Need phillips screw driver (included with trampoline) and 2 adjustable wrenches (for putting the trampoline together).
A
rubber
mallet is also recommended to make assembly easier.
• Assembly requires two adults. Keep children away from the trampoline and enclosure until they are completely put together.
• Use gloves to protect your hands from pinch points during assembly.
• Make sure that the trampoline is properly put together, with the frame pad correctly laid out, before you put together the trampoline
enclosure.
• The assembly steps refer to parts by their descriptions and key numbers (see the
PAR
TS LIS
T
on page 13 and make sure that all
listed parts are included. If a part is missing, refer to ORDERING REPLACEMENT
PAR
TS at the bottom of page 13.
TR AMPOLINE PLACEMENT
1. Place the trampoline and enclosure on a level surface before you use it.
2. Adequate overhead clearance is essential.
A
minimum of 24 feet (7.3 meters) from the ground is recommended. Provide clearance
from wires, tree limbs, and other possible hazards. Lateral (sideways) clearance is also essential. Place the trampoline and enclosure
away from walls, structures, fences, and other play areas. Maintain a clear space on all sides of the trampoline and enclosure.
3. Use the trampoline in a well-lighted area. If the trampoline is indoors or in a shady areas you may need to use artificial (electrical)
lighting in the area.
4. Secure the trampoline and enclosure against unauthorized and unsupervised use.
5. Remove any objects from under the trampoline and enclosure.
6. The owner and supervisors of the trampoline are responsible to make all users aware of practices specified in this manual.
7. The trampoline enclosure is only to be used as an enclosure for a specific round trampoline.
T
rampoline Assembly
ASSEMBLY (PUTTING THE TRAMPOLINE AND ENCLOSURE TOGETHER)
IMPORTANT ASSEMBLY INFORMATION
1
2
3
1
Socket
Socket
4
4
5
5
6
6
1
3
8
8
8
8
8
9
9
9
9
9
9
7
7
7
7
7
9
13
9
Make sure that you understand the information in the box at th top of this page
1
, Lay two Top tubes(1) with socket and the Corner tube(3)
on the ground in the position as shown.
Make sure the Top tubes and corner tubes are turned so small holes
(Spring holes) are facing the gound.
Insert one end of the corner tube(3) into one Tope tube(1), and insert the other
end of the corner tube into the other Top tube(1)
2
, Insert one end of right leg(4) into the left leg(5) secure with
M6X52mm Bolt(7) and M6 Nut(8) and washer (9).
Y
3
, Insert the assembled leg into the leg extension(6) secure with
M6X52mm Bolt(7) and M6 Nut(8) and washer (9).
Insert one leg halfway into the Socket. Pull out on the other leg
and insert into the Socket, press down on both legs at the same
time and fully insert them into the Socket secure with M6X52mm
Bolt(7) and M6 Nut(8) and washer (9).
Repeat steps,1,2 and 3 three additional times to assemble three
more leg sections.
Notice: Do not tighten the Nuts
Notice: Do not tighten the Nuts
