5
、
6
、
13
Repeat this process to assemble the rest of the Foams(16 and 17)
Insert the M5 Bolt(19) until it touches the nut in the Hexagon hole of the pole cap, securing
them together
to the tubes(1 and 2) by same manner
Insert the Straight Tube A(1) into the Short Foam(16), then insert the
Note: There is a Hexagon hole on the pole cap(18) with a nut inside as shown A. Insert the
pole cap(18) through one strap ring on the top edge of the enclosure mesh as shown in Inset
Drawing B.
Make sure the Hexagon hole side of the cap is against the mesh, and the holes
on both the strap ring and the caps are aligned.
Straight Tube B(2) into the Long Foam(17) as shown( not shown the net)
17
16
1
2
1
2
Inset drawing
C
Holes
B
Strap
18
Hole
19
Hole
A
18
Hexagon hole
Blue
Yellow
Gre
en
Red
