16
17
ASSEMBLY
ASSEMBLY
2.
Leg x5
Self-tapping screw x15
11
3
11
Insert one leg (3) into a big diameter tube of the frame (1) as shown. Then tighten with a self-tapping screw
(11) using the provided screw driver.
Repeat this process until all five legs have been attached to the frame.
11
tool
1
3
3.
Elastic with ball x25
Mat with enclosure net x1
11
6
4
Place the mat with the attached enclosure net (4) inside
of the frame. Align the mat so that the opening of
the enclosure is centered between two legs. Use one
elastic with ball (6) to attach the mat to the frame at the
enclosure door (see A).
Attach 4 more elastics with balls using the below
drawing for placement order. (Place in order of A, B, C,
D, E). Continue to place the elastics in this even pattern
until all 25 elastics with balls have been attached.
To attach the mat to the frame with the elastics with
balls, thread the elastic through the loop on the mat
and pull around the frame. Then loop the elastic
around the ball to hold in place.
Note:
The placement pattern helps keep the mat
centered and the tension on elastics even. If the
mat is not staying centered inside the frame,
adjust the mat by pulling the elastics with balls
as you work.
After this step is completed, the frame may not
lay flat on the ground. The frame will straighten
out with further assembly.
Note:
The balls on the elastics should be facing
the ground as shown to the right.
Big diameter tube
Fasten the self-tapping screw (11) with
tool (14)
Opening of enclosure should
be located in the middle
between two legs
Tool
4
B
C
D
E
