20
21
ASSEMBLY
ASSEMBLY
8.
Rail x5
11
2
Locate a rail (2) and insert the rail into
the foam (10) inside one of the sleeves as
shown.
Repeat this step until all five of the rail
sections have been inserted into the
foam and sleeves. Make sure the rails are
curving in, and the ends are alternating to
ensure one rail will fit inside the other.
Do not insert the poles into each other
during this step.
10
2
9.
Push the ends of the rails (2) out of the net holes to the outside of the net. Insert the bigger end of one rail into the
short horizontal tube located on the curved tube (7). Then, insert the small end of the adjacent tube into the big end as
shown.
Repeat this step to connect the remaining rail pieces.
When you reach the last curved tube that has not yet been placed, insert it into the leg piece and connect the last rail
tubes to complete the circle.
1
2
3
4
7
7
10.
Place a strap at the top of the enclosure net over the pole cap (12) as shown.
Repeat this step until all the straps have been placed around the pole caps and the enclosure net is completely upright.
11.
Insert a self-tapping screw (11) into the hole at the bottom of a curved pole. Tighten to secure the pole to the frame.
Repeat this step until all poles are secure.
Sleeve
Big end
Big end
Small end
Small end
Small end
Big end
Big end
Big end
Curved tube
Short horizontal
tube
Two holes between
two sleeves
12
11
Strap ring
Small end
Big end
