SkyTracker STX-1-2000, Инструкция по эксплуатации

Страница: 28 / 52

9.0 BULB REMOVAL
DANGER
Wear all required protective clothing and follow prescribed steps carefully.
1. If the xenon bulb has been in operation, wait at least 15 minutes after
Lamp shutdown (with blowers operating), before opening the lamp-
head. This will allow the internal lamp pressure to reduce to a level
that is permissible for handling, provided that the specified protective
clothing is worn.
2. Reverse the steps of the Lamp Installation Procedure in section 8.0.
10.0 ROUTINE SERVICE AND MAINTENANCE
1.1 PERIODIC MAINTENANCE
Except for unusual conditions of use (dirty environment, flooding, non-passive bulb failure,
etc.) the frequency of service and replacement of certain parts and components because of
normal wear is directly related to hours of use.
Inspection and preventive maintenance should be preformed approximately every 250
hours of use or every 3 months (whichever occurs first). The period can be adjusted ac
-
cording to actual circumstances. The following items are to be included at the time of each
periodic servicing:
10.1.1 BASE
1. Remove and replace the intake air filter.
2. Inspect and tighten timing belt, idlers, pulleys and sprockets.
3. Inspect and lube the drive motor and chain.
4. Remove, lubricate, and reinstall blower motors.
5. Inspect and tighten, as required, all electrical connections.
6. Tighten all mounting bolts.
7. Inspect all of the flexible cooling ducts.
10.1.2 XENON LAMPHEAD ASSEMBLIES
NOTE: See Section 8.0 for safe handling instructions of xenon bulbs.
1. Remove lamphousings and the xenon bulbs (Section 9.0).
2. Inspect and tighten all electrical connections.
3. Inspect all focus mechanisms. Lubricate focus screws.
24