Skytech: TS-R-2A Wireless Thermostat
REV. 11-14-18 Page 1
INSTALLATION AND OPERATING INSTRUCTIONS
IF YOU CANNOT READ OR UNDERSTAND THESE INSTALLATION INSTRUCTIONS
DO NOT ATTEMPT TO INSTALL OR OPERATE
Model: TS-R-2A
INTRODUCTION
This SKYTECH remote control system was developed to provide a safe, reliable, and user-friendly remote control system
for gas heating appliances. The system can be operated thermostatically or manually from the transmitter. The system
operates on radio frequencies (RF) within a 20-foot range using non-directional signals. The system operates one of
1,048,576 security codes that are programmed into the transmitter at the factory; the remote receiver’s code must be
matched to that of the transmitter prior to initial use.
WALL MOUNT THERMOSTAT
The wall/transmitter operates on (2) 3V Button Cell (Included) which powers
the LCD screen and powers the RF signal. These batteries are made
specifically for remote controls and electronic lighters. Before using the
transmitter the 3V batteries must be installed into the battery compartments
It is recommended that CR2032 lithium batteries always be used for longer
battery life and maximum operational performance.
Upon initial use, there may be a delay of five seconds before the remote
receiver will respond to the transmitter. This is part of the system’s design.
If the LCD screen will not come ON, check the 3V Button Cell battery.
ROOM
TEMP
THERMO
MODE
“SET”
ON
SET
OFF
LCD
DISPLAY
ON/UP
BUTTON
OFF/DOWN
BUTTON
SET
BUTTON
TO INSTALL BATTERIES IN THE WIRELESS THERMOSTAT
1. Remove face from backing plate this is done by sliding the face up
about 1/2” then pull the face off the base plate. As shown in Figure 1
2. Locate the (2) holders for the 3V button cell batteries.
3. Slide the button cell batteries into the battery holders. (Make sure that
the batteries are installed with the (+) plus side facing you or up.
(2) 3 Volt Button
Cell Batteries
Battery
Removal
Slots
Plus
Side
+
Plus
Side
+
Figure 1
Figure 2
ROOM
TEMP
ON
OFF
SET
