___________________________________________________________________________________________________________
REV 7/10/15
Page 4 of 5
Skytech TM/R 2-A
WIRING ELECTRONIC SPARK IGNITIONS
The remote control receiver can be connected, in series between a 24VAC transformer
and the TR terminal on the ELECTRONIC MODULE. Connect the hot wire from the
24VAC transformer to either of the wire on the remote receiver. Connect another wire
(included) between the other receiver wire terminal and the TH (thermostat) terminal on
the ELECTRONIC MODULE.
SYSTEM CHECK
MILLIVOLT VALVES
Light your gas appliance following the lighting instructions that came with the appliance. Confirm that the pilot flame is on; it must be in
operation for the main gas valve to operate.
•
Slide the 3-position button on the remote receiver to the ON position. The main gas flame (i.e., the fire) should ignite.
•
Slide the button to OFF. The flame should extinguish (the pilot flame will remain on).
•
Slide the button to REMOTE (the center position), and then press the ON button on the transmitter to change the system to ON.
The main gas flame should ignite.
ELECTRONIC IGNITION SYSTEMS
•
Slide the 3-position button on the remote receiver to the ON position. The spark electrode should begin sparking to ignite the pilot
(the pilot may ignite after only one spark). After the pilot flame is lit, the main gas valve should open and the main gas flame
should ignite.
•
Slide the button to OFF. The main gas flame and pilot flame should BOTH extinguish.
•
Slide the button to REMOTE (the center position), and then press the ON button on the transmitter to change the system to ON.
The spark electrode should begin sparking to ignite the pilot. After the pilot is lit, the main gas valve should open and the main gas
flame should ignite.
GENERAL INFORMATION
MATCHING SECURITY CODES
Each transmitter uses a unique security code. It will be necessary to press the LEARN button on the receiver to accept the transmitter
security code upon initial use, if batteries are replaced, or if a replacement transmitter is purchased from your dealer or the factory. In
order for the receiver to accept the transmitter security code, be sure the slide button on the receiver is in the REMOTE position; the
receiver will
not
LEARN if the slide switch is in the ON or OFF position. The LEARN button in located on the front face of the receiver;
inside the small hole labeled LEARN. Using a small screwdriver or end of a paperclip gently
Press and Release
the black LEARN
button inside the hole. When you release the LEARN button the receiver will emit an audible “beep”. After the receiver emits the beep
press the transmitter ON button and release. The receiver will emit several beeps indicating that the transmitter’s code has been
accepted into the receiver.
PROGRAMING MULTIPLE TRANSMITTERS TO THIS RECEIVER
NOTE: This receiver can hold from (1) to (3) different transmitter codes. This is for the times when a hand held transmitter or a second
wall transmitter is required.
1. Press and release the
LEARN
button on the receiver.
2. When you hear the “Beep”, press and hold the ON or OFF button for about 2 seconds on the transmitter.
3. A confirming series of “Beeps” will come from the receiver to indicate that the receiver has accepted the transmitter code.
Then the receiver will operate with both transmitters.
4. When the
LEARN
button is pressed and the receiver makes NO “Beep” sound this indicates that the receiver is unable to
accept any more transmitter codes.
5. To clear the codes from the receiver and start programming over or add new transmitters, press and hold the
LEARN
button in
for (10) seconds and release. Then, the receiver will emit a series of “Beeps,” indicating that the receiver has cleared all codes
and is ready to accept new codes.
ELECTRONIC MODULE
TR
TH
REMOTE
RECEIVER
neutral wire
24VAC
hot wire
120VAC
110/24VAC
Transformer
www.FireplaceRemoteControls.com
1.888.977.6849
