background image

REV.  1/26/06 

Page 1 of 9

 

 
 

                   

 

    SR 1001 TH  

(SKY MRCK TH-1)

 

INSTALLATION AND OPERATING INSTRUCTIONS

 

 

MULTI-FUNCTION WIRELESS REMOTE CONTROL SYSTEM 

FOR OPERATING SERVO MOTOR VALVE, MANUALLY AND WITH A THERMOSTAT FUNCTION  

 
 

 
 
INTRODUCTION 

This remote control system was developed to provide a safe, reliable, and user-friendly remote control system for gas heating 
appliances.  The system is operated manually from the transmitter.  The system operates on radio frequencies (RF) within a 20' range 
using non-directional signals.  The system operates on one of 1,048,576 security codes that are programmed into the transmitter at the 
factory; the remote receiver's code must be matched to that of the transmitter prior to initial use.  

 

Review THERMO SAFETY SECTION under RECEIVER section.  This high temperature safety feature shuts 
down the appliance when a potentially unsafe condition exists. 

 

 

 

TRANSMITTER 

 

This remote control SYSTEM offers the user a battery-operated remote control to 
power up to a 6 VDC servo motor or solenoid such as those used with gas valves 
used in some heater rated gas logs, gas fireplaces and other gas heating 
appliances. 
 
The servo motor or solenoid circuit uses the battery power from the receiver to 
operate a servo motor or solenoid.  The circuit has reversing polarity software 
which reverses the positive (+) and negative (-) output of the receiver's battery 
power to drive the servo motor forward/backward. (HI/LO FLAME) The SYSTEM 
is controlled by the remote transmitter. 
 
The transmitter operates on a (2) 1.5V AAA batteries.  
 
It is recommended that ALKALINE batteries always be used for longer battery life 
and maximum operational performance. 
 
Before using the transmitter, install the (2) AAA transmitter batteries into the 
battery compartment. (Use caution that batteries are installed in the proper 
direction) 
 
 
 
 

KEY SETINGS 

 

 

 

ON/HI  

-Operates unit to on position, Manually operated  

 

 

  servo HI. 

 

LO/OFF 

- Operates unit to off position, manually operated  

 

 

  servo LO. 

 

MODE  

- Changes unit from manual mode to thermo mode. 

 

SET  

- Sets temperature in thermo mode. 

 
 
 
 
 
 
 
 

ON/HI

MODE

LO/OFF

SET

1

2

3

4

 

IF YOU CANNOT READ OR UNDERSTAND THESE INSTALLATION INSTRUCTIONS DO NOT 

ATTEMPT TO INSTALL OR OPERATE  

ON/HI

MODE

LO/OFF

BUTTON

WALL CLIP

SLOT

BATTERY

COMPARTMENT

FRONT

BACK

LO/OFF

SET

ON/HI

BUTTON

MODE

BUTTON

SET

BUTTON

 

www.FireplaceRemoteControls.com

1.877.374.4404

Содержание SR 1001 TH










Отзывы: