Skytech: MRCK
(SR1001-1)
REV. 6-8-17 Page 3
WIRING INSTRUCTION
CONNECTING THE RECEIVER TO A HI/LOW SERVO MOTOR STYLE VALVE SYSTEM
1. Connect the BLACK 18 gage stranded wire with the 1/4” female terminal from the receiver to the 1/4” male terminal on
the valve servomotor.
2. Connect the Black 18 gage stranded wire with the 3/16” female terminal from the receiver to the 3/16” male terminal
on the valve servomotor.
3. After receiver wires are connected to the valve servo motor terminals make sure the receiver shield is located over the
receiver and then locate the receiver in an area that will not exceed the 120° F.
4. Depending on the product that this remote control system is used on the 1/4” female terminal and wire from the
receiver and the 3/16” female terminal and wire may need to be cut to a shorter length. This can be done by removing
the (2) wires from the receiver cutting them to the desired length then reinstalling them into the same connections on
the receiver.
5. The receiver can be mounted on the side of a valve kit. NOTE: Always mount the receiver to side of the valve kit away
from the fire.
IMPORTANT NOTE
:
Operation of these controls is dependent on which wire is attached to which terminal. If operation
of control does not correspond to operating buttons on transmitter, reverse wire installation at the receiver or at the
control. Up to 6 VDC of power is provided at the receiver terminal.
LEARN
REMOTE
ON
OFF
¼”
Female Terminal
³⁄16”
Female Terminal
¼”
Female Terminal
³⁄16”
Female Terminal
(Back of Receiver)
O
N
OFF
PI
LO
T
IG
N O
FF
ON
1/4” Male
Terminal
HI/LO STYLE SERVO
MOTOR VALVE
3/16” Male
Terminal
Pilot Adjustment
GENERAL INFORMATION
LEARNING TRANSMITTER TO RECEIVER
Each transmitter uses a unique security code. It will be necessary to press the LEARN button on the receiver to accept
the transmitter security code upon initial use, if batteries are replaced, or if a replacement transmitter is purchased from
your dealer or the factory. In order for the receiver to accept the transmitter security code, be sure the slide button on
the receiver is in the REMOTE position; the receiver will not LEARN if the slide switch is in the ON or OFF position. The
LEARN button in located on the front face of the receiver; inside the small hole labeled LEARN. Using a small screwdriver
or end of a paperclip gently press the black LEARN button inside the hole and release the button. When you release the
LEARN button the receiver will emit a “beep”. After the receiver emits the beep press any button on the transmitter and
release. The receiver will emit several beeps indicating that the transmitter’s code has been accepted into the receiver.
The microprocessor that controls the security code matching procedure is controlled by a timing function. If you are
unsuccessful in matching the security code on the first attempt, wait 1 - 2 minutes before trying again--this delay allows
the microprocessor to reset its timer circuitry--and try up to two or three more times.
