Cradle Bracket
Cradle Bracket
Incoming Gas Line
Valve Box
Valve Box
Gas Shut-Off Vale
Figure 7.
TFS (Thermocouple Flame Sense) plumbing diagram.
Key
Figure 5
. Inserting Key into Valve
Figure 6.
Lighting fire pit with lighter
TURNING OFF FIRE PIT
1. Insert key into each shut-off valve and secure into
square end.
2. Turn key clockwise until it stops.
3. Repeat steps 1 and 2 for the second burner.
3. After cooling off install cover.
Butane Ligh
ter
End View
THERMOCOUPLE FLAME SENSE (TFS) INSTALLATION
THERMOCOUPLE FLAME SENSE (TFS) LIGHTING INSTRUCTIONS
READ ALL WARNINGS AND SAFETY INFORMATION IN INSTALLATION MANUAL BEFORE ATTEMPTING TO
LIGHT FIRE PIT
LOW
HI
OFF
ON
Figure 8
. Transmitter
TURNING ON FIRE PIT
1. Ensure you have leak tested the fire pit before operating. Turn main gas supply ON.
2. Ensure batteries are installed in battery pack and switch is on Latching Solenoid.
3. Press the
ON
button on the transmitter. You will hear the ignitor probe will begin sparking
for up to 20 seconds and the fire pit will turn ON.
4. If the fire pit does not light the module will “beep” one time every second indicating an
ignition error. This is a hard lockout. If this occurs press the
OFF
button on the remote
control and repeat step 1-3.
5. If fire pit does not light after second try turn main gas OFF, wait 5 minutes and repeat
steps 1-3.
NOTE
: It may take several cycles of ON/OFF to purge the airflow from the gas lines. The direct spark ignition
will turn OFF after 20 seconds if the burner does not light after which you will need to press transmitter OFF button then
back ON to initiate ignition again.
Flame height can be adjusted HI and LO. After the fire pit is operating press the hand-held transmitter HI or LO. The
transmitter defaults to the HI setting when initially lighting the fire pit each time or if attempting to re-light but will
remember the last setting used and change back to that last setting in approximately 5 seconds after lighting.
TURNING OFF FIRE PIT
1. To turn OFF the fire pit press the OFF button on the transmitter. Fire pit will turn OFF.
2. After fire pit has completely cooled off install cover.
REV. 4-6-16
