I-MT REV. 7-23-15 Page 10
FIRE PIT MAINTENANCE
1. The fire pit should be inspected and cleaned before initial use at least annually by a qualified field service person.
2. Any component that is found faulty must be replaced with an approved component.
3. Any tampering or modifying with the fire pit is dangerous and voids all warranties.
4. During winter months in cold climates and various seasons operation the fire pit may be affected by weather
conditions. It is recommended to use a ventilated cover overtop of your fire pit to protect it from humid/rainy weather
conditions when not in use. Heavy rains/downpours could affect the fire pit operation if not covered; if this occurs
ensure you allow the fire pit time to dry out before attempting to operate.
NOTE
: If a combustible type cover is used
over the fire pit when not in use be sure to remove it before operation to prevent a severe safety hazard.
5. Over time stainless steel parts can discolor when heated, usually a golden or brown hue. This discoloration is normal
and does not affect the performance of the appliance.
TROUBLE SHOOTING
Symptom
Remedy
Fire pit won’t light
1. Bleed gas line.
2. Ensure all gas supply lines are turned ON.
3. Ensure there is not too much media overtop of burner; it can inhibit gas from flowing.
4. Check gas pressure.
Low flame
1. Ensure the base media is at least 1-inch in diameter and top media is no more than 1-inch over
top of burner.
2. Ensure all shut-off valves and key valve is fully open. See page 7; figure 6
3. Check gas pressure.
Water in my fire pit
1. Excess dust/sand material from media may be blocking the weep holes to relieve water.
Remove all media and unplug weep holes. Clean or install new media free of dust and dirt.
2. Ensure fire pit enclosure has proper drainage for water and proper ventilation to dry out.
MT Burning Spur Fire Pits
ACCESSORIES
The following accessories are available from your local Firegear dealer/distributor.
Each accessory comes with a separate installation manual. Read each instruction thoroughly before installing.
Stainless Round Lid for 19” - 33” Pits
Models
: LID-16R, LID-19R or LID-25R
Lava Stones 1” to 2” size.
Model
: FG-LS15 (15lb. jug),
FG-LS50 (50lb. bag)
Stainless Square Lid for 20” - 38” Pits
Models:
LID-20S, LID-26S, LID-32S,
LID-38S
Lava Boulders 6” to 12” size
Model
: FG-LB30 (30lb. box)
Lava Rock 1” to 2”diameter
Model
: FG-LAVA-10 (10lb. jug),
FG-LAVA50 (50lb bag.)
Conversion Kit
: Converts fire pit
from Natural to LP Gas. Includes:
OAS, rating plate label sticker and
instructions
Models:
LP Orifice #
FPB19 OAS-LP31
FPB25, 26, 29 OAS-LP35
FPB32, 33 OAS-LP29
FPB38 OAS-LP25
