_________________________________________________________________________________________________________________________
REV 8/29/11 Page 4 of 6
Model: 4001TH
To attach Cover Plate to Receiver box
Position the receiver as shown in diagram to the left with lower
tab on cover plate inserted into groove of receiver make sure
the cover plate properly aligns with remote receiver. Pull Receiver
up and snap into top tab of cover plate.
Position the cover plate so the word ON is facing up; then, install
the remote receiver into the plastic switch box using the two long
screws provided. Push the White Button over the receiver slide
switch. Make sure the remote receiver code switches has been set
to match the transmitter code switches before completing the
installation Note: Code setting section.
NOTE: The remote receiver will only respond to the transmitter when the 3-position slide button on the remote receiver is in the
REMOTE position. If the system does not respond to the battery transmitter on initial use, see CODE SETTING SECTION,
and recheck battery positions in the remote receiver.
HEARTH MOUNT
The remote receiver can be placed on the fireplace hearth or under the fireplace, behind the
control access panel. Position where the ambient temperature inside the receiver case does
not exceed 130
0
F
. Battery life is also significantly shortened if batteries are exposed
to high temperatures. Make sure the remote receiver code switches has been set to
match the transmitter code switches before completing the installation
Note
: Code setting section
.
NOTE: Black Slide Button is used for Hearth Mount applications.
WIRING INSTRUCTIONS
A qualified electrician or a gas technician who is familiar with the gas appliance and gas valves that will be operated by this remote
should install the remote control system. Incorrect wiring connections
WILL
cause damage to the gas valve or electronic module
operating the gas appliance and may also damage the remote receiver.
WIRING MILLIVOLT VALVES
The remote receiver is connected to the millivolt valve using the TH (thermostat) terminals on the terminal block on the millivolt gas
valve. Connect 18 gauge solid or stranded wires from the remote receiver to the gas valve.
Operation of the remote receiver is similar to that of a thermostat in that both turn the gas
valve
on and off based on input signals. A thermostat’s input signals are different temperatures.
The
remote receiver’s input signals come from the transmitter.
Connect one of the two wires leading from the receiver to the TH terminal and the other to
the TH/TP terminal on the millivolt gas valve it does not matter which wires go to which
terminal.
WIRING ELECTRONIC SPARK IGNITIONS
The remote control receiver can be connected, in series between a 24VAC transformer
and the TR terminal on the ELECTRONIC MODULE. Connect the hot wire from the
24VAC transformer to either of the wires on the remote receiver. Connect the other wire
on the receiver (wires included) terminal and the TH (thermostat) terminal on the
ELECTRONIC MODULE.
Remote Receiver
Cover Plate
(Rear View)
WALL
Plastic Switch Box
Remote Receiver
Cover Plate
Receiver
Slide
Button
OFF
REMOTE
ON
OFF
ON
R
E
M
O
T
E
Wire terminals
Remote Receiver
REMOTE
ON
OFF
Code Switches
Slide Button
TERMINAL BLOCK
ON MILLIVOLT
GAS VALVES
TH
TP
TP
TH
THERMOPILE/
PILOT LIGHT
REMOTE
RECEIVER
ELECTRONIC MODULE
TR
TH
REMOTE
RECEIVER
neutral wire
24VAC
hot wire
120VAC
110/24VAC
Transformer
