___________________________________________________________________________________________________________
REV 6/7/11 Page 5 of 14
Skytech 3301P BE
PROGRAM REVIEW
If you want to review the settings for either the FACTORY program
and/or your CUSTOMIZED program, you may do so by pressing the
PROG button for one second. To review other
settings, press the PROG button allowing one
second between each press of the PROG button. If
you press the PROG button for 4 seconds, then you
go into the programming process. Press the SET button
should you hold the PROG button too long.
PROGRAM CANCELLATION
Should you want to cancel the CUSTOMIZED program that you have entered and return to the FACTORY program, you may do so. To
cancel a CUSTOMIZED program:
1. Press the SET button to make sure the LCD screen is in normal state.
2. Then press and hold the PROG button and, at the same time, press the SET button for a period of 10 seconds.
3. The customized programs will be cancelled when the display icons/numbers flash with some icons disappearing. The LCD screen
will begin flashing PROGRAM FOR, START AT, and the digits in the TIME and SET frames will begin flashing. This confirms
CUSTOMIZED programs have been cancelled.
4. Push the SET button to return LCD screen to normal state or wait 10 seconds and LCD screen will return to normal state
automatically.
ADDITIONAL PROGRAMMING OPTIONS SWING TEMPERATURE DIFFERENTIAL
The thermo-transmitter operates the fireplace system
whenever the ROOM TEMPERATURE varies a certain number
of degrees from the SET TEMPERATURE. This variation is
called the “SWING” or TEMPERATURE DIFFERENTIAL. The
normal operating cycle of a fireplace system may be 2-4 times
per hour depending on how well the room or home is insulated
from the cold or drafts. A smaller “swing number” increases
the number of cycles so the room temperature is more
constant. A larger “swing number” decreases the number of
cycles, which saves energy, in most cases. The factory setting
for the “swing number” is 2. This represents a temperature
variation of +/- 2
0
F
(1
0
C
) between SET temperature and
ROOM temperature which determines when the fireplace will
be activate. The “SWING” number values are:
1= +/- 1
0
F (.5
0
C), 2= +/- 2
0
F (1
0
C), 3 = +/-3
0
F (1.6
0
C).
1
To change the temperature “SWING” setting (1-3), press the
AHEAD + BACK buttons simultaneously to display the current
“SWING”
2
setting in the SET TEMP frame. The word SWING will display on
the LCD screen.
3
Press the UP or DOWN button to change the temperature
differential or “SWING” (1-3). See above for 1-3 “SWING”
temperature values.
4
To store the “swing number”, press the SET button or allow 15
seconds to lapse, and the new “swing number” will be
automatically programmed.
MANUAL CHECK OF “SWING” OR TEMPERATURE DIFFERENTIAL
The operation of the factory set “THERMO SWING” can be checked by adjusting the SET TEMP 2
0
F
above or below the room
temperature. This will cause the system to turn ON or OFF. Normally the system will only respond to temperature changes every two
minutes. Manually changing the SET temperature will activate the system in less than 10 seconds. If the “SWING” is changed, then a
new room temperature differential will respond. Factory setting of SWING temperature is 2
0
F
.
TIME
SET
AM
START
AT
PROGRAM
FOR
SU
MORN
1
UP
DOWN
MODE
TIMER
TIME
SET
PROG
AHEAD
BACK
SWING
1
2
3
UP
DOWN
MODE
TIMER
TIME
SET
PROG
AHEAD
BACK
f i r e - p a r t s . c o m
