___________________________________________________________________________________________________________
REV 6/7/11 Page 11 of 14
Skytech 3301P BE
Note: 3301P BE system will need to be re-energized every
time the pilot light is turned to the OFF position or the pilot
light goes out for any reason. This is done by depressing
and holding the ENERGIZER BUTTON for minimum of 60
seconds.
Note: The Energizer Button must be held in for minimum of
60 seconds
TIMER
The countdown timer will operate in either the manual ON or THERMO mode. Once the appliance is in an operating mode, set the
countdown timer to turn off in 15 minutes. The timer function will allow operation to continue until the countdown “time” on the LCD
screen expires. After 15 minutes elapses, the system should turn OFF.
If you have any problems with operation, recheck you connections and ensure transmitter batteries are fully charged. If no problem is
found, contact the dealer where you purchased your appliance/remote control.
GENERAL INFORMATION
LEARNING TRANSMITTER TO RECEIVER
Each transmitter uses a unique security code. It will be necessary to press the LEARN button on the receiver to accept the transmitter
security code upon initial use, if batteries are replaced, or if a replacement transmitter is purchased from your dealer or the factory. In
order for the receiver to accept the transmitter security code, be sure the slide button on the receiver is in the REMOTE position; the
receiver will
not
LEARN if the slide switch is in the ON or OFF position. The LEARN button in located on the front face of the receiver;
inside the small hole labeled LEARN. Using a small screwdriver or end of a paperclip gently press and release the black LEARN button
inside the hole. When you release the LEARN button the receiver will emit an audible “beep”. After the receiver emits the beep press
the transmitter MODE button and release. The receiver will emit several beeps indicating that the transmitter’s code has been accepted
into the receiver
The microprocessor that controls the security code matching procedure is controlled by a timing function. If you are unsuccessful in
matching the security code on the first attempt, wait 1-2 minutes before trying again – this delay allows the microprocessor to reset its
timer circuitry – and try up to two or three more times.
THERMO FUNCTION
When the transmitter is in the THERMO mode, it should be kept away from direct sources of heat such as fireplaces, incandescent
lighting, and direct sunlight. Leaving the transmitter in direct sunlight, for example, will cause its heat-sensing diode to read the room
temperature higher than it actually is; if in THERMO mode, it may not turn on the appliance even if the ambient ROOM temperature is
below the SET temperature.
TROUBLE SHOOTING
Should you encounter problems with your fireplace system, the problem may be with the fireplace itself or it could be with the
SKYTECH remote control. Review the fireplace manufacturer’s operation manual to make sure all connections are properly made.
Then check the operation of the SKYTECH remote in the following manner:
1. Check connections from the receiver to the control valve for good positive connections. (Move the slide switch on the receiver to
the ON position if the appliance operates this will confirm that the wiring connections should be good).
2. Check for power from the thermopile to the receiver the voltage with the main burner OFF be no less than 450 millivolts. (Press the
learn button on the receiver if there is a beep sound from the receiver this will confirm there is power to the receiver from the
thermopile).
3. Be sure the transmitter’s batteries are properly installed and that the battery output is 2.5 V or more.
4. Check to make sure the transmitter is communicating with the receiver.
•
If the receiver beeps when the MODE button is depressed on the transmitter they are communicating.
•
If the receiver does not beep when the MODE button is depressed on the transmitter, you will need to teach the receiver the
code of the transmitter. This is done by holding the LEARN button down on the receiver and at the same time depress the
Energize Button
f i r e - p a r t s . c o m
