REAR BRAKE LIGHT SWITCH
The rear brake light switch is located below the right frame cover. To adjust
the rear brake light switch, lift up or down the switch (adjust the nut)until the rear
brake light turns on when the brake pedal is stepped down.
TIRES
Tire inflation pressure and tread should be checked regularly. To ensure a
good performance and long service life, check your tires frequently for both wear
and inflation pressure.
TIRE PRESSURE
Improper tire pressure will not only quicken tire weariness but also seriously affect the stability of the
motorcycle. Insufficient pressure will make turning difficult. Too high pressure will cause less contacting
area of the tire with the ground, which will bring the slippery or even the loss of control. Be sure to make
the tire pressure in the stipulated limits. Adjust the air pressure correctly when the tires are cold.
Front tire pressure: 250kPa Rear tire pressure: 250kPa
TIRE TREAD CONDITION
Operating the motorcycle with excessively worn tires will decrease riding stability and can lead to loss
of control. It is recommended that the front and rear tires be replaced when the remaining depth of tire
tread becomes 1.6mm or less.
40
LIGHTING BULBS
When you change a burned light bulb, you must use the bulb of the same power. The use of bulbs with
power higher than rated power will cause the overload of the whole circuit or the light to burn too early.
Rated powers for bulbs please refer to “electrical system” in “specification list” of this manual.
FUSE
The fuse is located under the side cover and beside the battery. The whole electrical system is protected
by one fuse. If the engine suddenly stopped during the ride or electrical system is cut, you should inspect
the fuse first.
WARNING
The standard of the tires of your motorcycle is: 3.50-8 4PR(front and rear tires). Using other
types of tires may cause problem. We suggest you choose standard tires Skyteam provided.
The pressure and condition of tires are very important to the function and safety of the
motorcycle. Please check frequently the weariness and pressure condition.
41
NOTE
Be sure to use the fuse with right electrical flow. Do not use aluminum or iron thread to
replace it. If the fuse often melts, that means that the electrical system has problem. You should
inspect in the Skyteam service station.
