8
3.2 Operation Procedures
3.2.1 Verify that this firm equipment in your workplace.
3.2.2 cutting Regulator
To perform several cuts in the same thickness, adjust the regulator to Cut N° 07 (fig. 01)
as desired. For this purpose turn the throttle Lever counterclockwise Court releasing the
same. Then drive the regulator until the desired thickness.
Firmly tighten the throttle Lever.
3.2.3 Blade
The cutting blade must be installed with the teeth facing front of machine and pointing
down.
To gauge (stretch) the blade N° 05 (fig. 01), rotate the handle of the blade Gauge N° 1 (fig.
01) clockwise until it stops.
3.2.4 Wheel Bottom
The Bottom steering wheel N° 09 (fig. 01) is mounted on the bearing shaft bottom and
arrested by the Clip N° 06 (fig. 01), this Clip should always be positioned in the Groove of
the shaft.
The Bottom steering wheel can be removed for cleaning after removing the Blade (see
item 3.3 cleaning).
3.2.5 Wheel Top
The Upper steering wheel N° 04 (fig. 01) has incorporated into its structure the shaft and
bearings.
The Upper steering wheel can be removed for cleaning after removing the Blade (see item
3.3 cleaning).
