20
6. Maintenance
The maintenance must be considered a set of procedures that aims to keep the equipment
in optimum operating conditions, resulting in increased service life and safety.
* Cleaning – Check item 3.3 of this manual Cleaning.
* Wiring-Check all the cables on the decay and all contacts (terminals) on the grip and
electric corrosion.
* Contacts – on/off switch, emergency stop button, reset button, electronic circuits,
etc. Check the equipment so that all components are functioning properly and that the
operation of the appliance is normal.
* Installation – check the installation of your equipment according to item 2.1, Installation
of this manual.
* Product life – 2 years, for a normal work shift.
1-items to check and perform monthly:
-Check the wiring;
-Measure the voltage from the socket;
-Measure the operating current and compare with the nominal;
-Check tightness of all electrical terminals of the unit, to avoid possible bad contacts;
-Check possible furloughs electric motor shaft;
-Check the wiring and electrical cable for signs of overheating, poor insulation or
mechanical failure.
2-checking Items or perform every 3 months:
-Check electrical components like power switch, emergency stop button, reset button and
electronic circuit for signs of overheating, poor insulation or mechanical failure.
-Check possible clearances in bearings and bearings.
-Check seals, rings o’rings, v rings rings and other fencing systems.
