05
3.2 – Feeding Procedure
These blenders work in hight speed (approximately 18.000rpm).
To feed the blender proceed as follows:
- Cut the product in small pieces of up to 2cm size. This process helps on
blending time mainly for frozen products. When triturating ice, it is recommended to
drop some water inside the cup.
- Take out the lid No. 05 (Picture 02). - Place the product to be processed into
the cup No.04 (Picture - 02) with the
-machine switched OFF. - Place the lid back No. 05 (Picture 02) and switch the
machine ON.
3.3 CLEANING
The blenders cup parts are resistant to corrosion, hygienic and easily cleaned.
Before using them for the first time and after each use, take apart the cup pieces (pic.
02) and clean them very well with warm clean water and neutral soap, wipe and dry
them well.
DO NOT WASH ANY PIECES IN A DISH WASHER.
Revise all the pieces frequently before assembling them again. If the blades
are stuck or turn with difficulty, DO NOT USE THE BLENDER. Do a review turning
carefully the blades anti- clock-wise (the opposed edges are sharpened): The blades
must move without difficulties.
Use only original SIEMSEN spare parts which are available at the Authorized
Dealer.
THE USAGE OF DAMAGED OR NOT RECOMMEND SPARE PARTS MAY
CAUSE SERIOUS PERSONAL HURTS OR DAMAGES TO YOUR BLENDER.
See on Page 03 (Pic. 02) all the steps to assemble the cup . NEVER DIP THE
MOTOR HOUSING IN WATER OR ANY OTHER LIQUID.could be exposed to severe
electrical shocks or even to a fatal situation.
IMPORTANT:
Always disconnected the machine from power source before cleaning
Clean base external side with a wet cloth.
Motor has permanent lubrication and does not need any additional lubrication.
ALL MAINTENANCE MUST BE DONE BY DEALERS TECHNICAL
ASSISTANTS.
ATTENTION
Keep the drain tube without obstructions.
08
4.2 Safety Procedures and Notes Before Switching Machine ON
IMPORTANT
Carefully read ALL INSTRUCTIONS of this manual before turning the machine
ON. Be sure to be familiar with the instructions and that you have well
understood all information contained in this manual. If you have any question
contact your supervisor or your nearest Dealer.
4.2.1 Danger
An electric cable or electric wire with damaged jacket or bad insulation could cause
electrical shocks as well as electrical leak. Before use, check conditions of all wires and
cables.
4.2.2 Advices
Be sure ALL INSTRUCTIONS in this manual have been thoroughly understood.
Every function and operational procedure have to be very clear to the operator. Contact
your nearest Dealer for further questions.
Any manual command (switch, button or lever) shall be given only after being
sure it is the correct one.
4.2.3 Precautions
The electric cable has to be compatible with the power required by the
machine. Cables touching the floor or close to the machine need to be protected
against short circuits.
Oil reservoir has to be full up to the required level as indicated. Check level
and add oil if necessary.
4.3 Routine Inspection
4.3.1 Advice
When checking the tension of the belts or chains, DO NOT introduce your
fingers between the belts and the pulleys and nor between the chain and the gears.
4.3.2 Precautions
Check if motors, belts, chains or gears and sliding or turning parts of the machine
produce abnormal noises.
Check the tension of the belts and chains and replace the set when belt, chain or
gears show signs of being worn out.
When checking tensions of belts or chain DO NOT introduce your fingers between
belts and pulleys, nor between the chains and gears.
Check protections and safety devices to make sure they are working properly.
