3
2.1 Available Discs
The Food Grater is a bench top machine developed to grate
or shred cheese or dried coconut, being also able to process
all kinds of vegetables, keeping their nutritious properties,
and also avoid wasting.
In table 02, the available blades and their cutting dimensions
and codes are indicated.
3. INSTALLATION AND PRE-OPERATION
3.1 Positioning
Your appliance must be positioned and leveled on a dry and
firm surface with a preferable height of 850 mm.
3.2 Electrical Installation
The feeding cable has 3 pins, and the central pin is for
grounding. It is mandatory that the 3 pins are turned on
before turning on the appliance.
3.3 Equipotencial terminal
The Picture presented below indicates the external
equipotential terminal.
It must be used to guarantee that there is no potential
difference between different equipment connected to the
power grid, diminishing the risk of electric shocks.
The distinct equipment must be turned on one to the other
by their own equipotential terminals
.
3.4 Safety system
For the safety of the operator, this appliance has 3 devices
that are capable of turning off the machine and preventing
accidents.
a -
For the safety of the operator, this appliance has 3 devices
that are capable of turning off the machine and preventing
accidents.
b -
The second device interrupts the operation of the
machine when the pushing bottom is on, opening the
feeding nozzle. When the pushing bottom returns to its
position, the machine starts automatically to work.
c -
The third device shuts down the machine’s motor in the
event of overheating. Wait a few minutes until the machine
cools down and turn it on again by pressing the ON Switch.
3.5 Replacement of the discs
To assemble and change the blades, follow the steps
informed below:
Step 1: Begin by choosing the correct blade for the work you
want to do, as per Table N°2;
Step 2: Loosen up the handle N°01 (Pic. 03) spinning it anti-
clock wise;
Step 3: Remove the feeding mouth N°02 (Pic. 03);
Step 4: Fit the chosen blade at the base of the disc. Make
sure it fits perfectly;
Step 5: Place the entire mouth set and tighten it up, spinning
the handle clock wise;
4. OPERATION
Never operate this appliance when close to the border
of the work surface.
•
Check
if the appliance is firm to the working area.
•
Before using the appliance, it is necessary to wash all
the components that have contact with the product
that will be processed with water and neutral soap.
4.1
Turning on the Appliance
Before turning on the equipment, check the following
procedures:
- Check if the feeding mouth is closed and correctly locked;
- Check if the pusher is correctly positioned inside the nozzle
BLADE
DEMONITATION CUTTING DIMENSIONS
CODE
Blade 4
Diameter of 4 mm 66208.9
Blade 8
Diameter of 8 mm 66226.7
Grating Blade
xxxxxxxxxxx
66195.3
Terminal
Table 02
01
02
03
PICTURE 02
PICTURE 03
PICTURE 04