5
•
Check the ON/OFF button, Reset button, electronic
circuits for signs of overheating, damaged insulation or
mechanical damage.
• Check for possible looseness in the assemblies and
bearings.
•Check the retainers, o’rings, v’rings and other seals.
7. OBSERVED NORMS
ABNT NBR NM 60335-1
IEC 60335-2-14
8. PROBLEM SOLVING
PROBLEMS
CAUSES
SOLUTIONS
- The equipment does not start.
- Energy Shortage.
- Problem with the electric circuit.
- Check energy supply.
- Call Technical Assistance.
- Burn smell or smoke.
- Problem with the electric circuit.
- Call Technical Assistance.
- The equipment switches ON but
when the product is placed inside the
cup the knife stops or turns slowly.
- Problems with the electric motor.
- Call Technical Assistance.
- Damaged cord.
- Problem during transportation.
- Call Technical Assistance.
- Strange noises.
- Damaged bearing.
- Call Technical Assistance.
- The product does not blend.
- Product pieces too large.
- Blunt knife.
- Cut product pieces 3,5cm wide.
- Call Technical Assistance.
- Cup leaking.
- Damaged sealing.
- Call Technical Assistance.
Use your
QR Code Reader
to access
more information regarding safety and
maintenance.
