Skymaster DCI 35, Руководство по эксплуатации

Страница: 14 / 22

GB 12
7. The OSD – User Installation
Antenna setting – DiSEqC 1.2 rotor control
Skip this chapter if you do not possess a DiSEqC 1.2 rotor. Note: When using a rotor, connect it to
a DiSEqC LNB.
1) Antenna: It is possible to carry out up to 16 different antenna configurations in connection
with various satellite selectors.
2) Type: Select the antenna type “DiSEqC 1.2”.
3) Satellite: Selection of the satellite which is to be received.
4) LNB type (default setting Digital-/DiSEqC-LNB): If you are using an older or uncommon
LNB, you have to enter the changes manually. Only change the values if you know the
technical data of the LNB!
5) LNB freq. 1 and 2: Display of the LNB frequencies (lower and upper oscillator frequency of
the LNB). The values for common digital and DiSEqC LNBs are 9750 (Osc. fr. LNB1) and
10600 (Osc. fr. LNB2). Please only change these values if it is expressly specified in the
assembly instructions of the satellite system!
6) 22kHz: Here it is possible to set whether the 22kHz signal for controlling 22kHz selectors or
special LNBs should be switched on or off. 22kHz selectors are no longer relevant for digital
reception systems. To prevent malfunctioning, set the setting for both selector types to “No”.
The 22kHz signal is automatically activated depending on the LNB type.
7) Satellite switch DiSEqC: Deactivate this function when using a rotor.
8) C/Ku band: To prevent malfunctioning, leave the setting as “No”. The C band is
predominantly received in the Middle East or Russia.
9) Set limit: Press the respective coloured button to open the following menu. Use this function
to set the most eastern and western swivel range of the rotatable DiSEqC 1.2 or USALS
antenna. This prevents the antenna from being damaged during rotation due to obstacles
(e.g. house wall, branches).
Rotate the antenna by pressing the left volume button
VOL- and confirm the position via OK .
Subsequently, a question is displayed which has to be answered with either “OK” or “Confirm”.
Repeat the process to set the western limits by pressing and holding the right volume button
VOL+ until the most western position of the antenna has been reached. Confirm the
subsequent question with OK .
10) Delete limits: To delete the stored eastern and western limits, select the option “Delete limit”
and press the OK button.
Caution: The DiSEqC rotor can now move unlimited again! The antenna might be damaged by
obstacles, e.g. railings, branches or house walls!
After carrying out all the changes, press the Exit button and confirm the safety query via OK to
activate all the changes.
Antenna setting – USALS rotor control
If you possess a USALS rotating system, all satellite positions can be automatically calculated. The
receiver requires the precise location of the antenna as the calculation basis.
Set limits: Press the respective coloured button to set the limits for the rotor. The procedure is
described in the previous chapter (Set DiSEqC 1.2 limits).
USALS setup: Press the green button to carry out the USALS settings. The antenna should be
exactly aligned to a satellite position (e.g. Astra 19.2° East).
Enter the following data for Hamburg:
Latitude: 53.6 North
Longitude: 10.0 East
After saving, the receiver is able to calculate all the distances of the satellites to each other and
approach the positions precisely. Prerequisite for this is 100% alignment of the USALS antenna!
Please refer to the assembly instructions of your rotating system if it is not possible to receive all
the available satellites!