FUSELAGE
Make sure you have a good stand for fuselage. You will need to assemble the rest of the
Hawk on this stand.
Remove the tank from rear fuselage.
Locate the 4 x M5 bolts and washers for
fuselage.
Align fuselage and secure with 4 bolts. Check fit
all around seem for sound joined.
Route servo wires and air lines from speed brake
neatly along inner skin of rear fuselage to nose.
Make sure no air line & servo wires can come in contact
with hot parts of turbine and pipe.
Turn fuselage upside down and remove the nose retract
unit.
Install JR DS8511 steering servo and centre servo.
Refit nose retract unit with good quality screws.
Operate unit and check operation. Close the door and
check clearance all around wheel.
Locate the slots for ventral
fins next to speed brake.
Mask off area and glue fins
in position.
For Hawk 100 additional fins
are located in front of
elevator. Mask off area and
glue fins in position.
P-18
Assembly & Operation Manual
Photo 29
Photo 30
Photo 33
Photo 31
Photo 32
Photo 34
Photo 35
