SKYLOTEC BEAMTAC 2.0, Инструкция по эксплуатации, Страница: 5 / 136

55
Depending on the situation, individual fall protection must be
observed even during set-up. The installation direction can be
chosen in accordance with Fig. 2. The working area (effective
direction of a fall) is within the radius shown in fig. 3 which extends
to 45° from the vertical. Any swing due to an ascent or descent
which is not vertical (45°) to the anchor (worst case direction of fall)
must be avoided at all costs.
max. 90°
Fig.3
Use of the beam clamp is only permitted for the purposes explained
in this document. No modifications must be made to the products.
Equipment subjected to a fall must be withdrawn from use
immediately. The general service life must, as part of the checks
carried out, be evaluated by specialist personnel on a case-by-
case basis. Based on the type of application, regular checks must
be carried out at least once a year by an expert or qualified
specialist personnel. Always clean with warm water (40°C) and a
mild soap solution, then rinse well with clear water, dry naturally
and keep away from direct heat. Only to be serviced by SKYLOTEC-
authorised service centres.
2.) BEAMTAC 2.0
the BEAMTAC 2.0 is type-tested as an anchor as per EN 795/B for
the use of one person.
Fig.4 Marking:
Follow the instructions
Marking of the supervisory body
Manufa address
Space for inspection label
Month and year of
manufacture
Serial number
Article number
Relevant
standards
max. number
of users
Article designation
Data Matrix
Skylotec GmbH
Im Mühlengrund 6-8
56566 Neuwied
Germany
+49 (0)2631/9680-0
www.skylotec.com