Skyjack SJIII 6826E, Руководство по эксплуатации

Страница: 17 / 26

SJIII Series E - The CONVENTIONALS
118931AH
May 2002
SECTION 2, Page 18
Start and Operation
Using the controls on the base:
1. Turn Emergency Power Disconnect Switch to
“ON” position. (CE rated machines pull out
Emergency Stop Button located on Base
Contro
l Station .)
2. Use the ladder at the rear of the work platform
to access the work platform deck.
3. Latch the entry chain/gate.
Using the controls on the platform:
Warning
TO PROTECT AGAINST UNINTENDED
MOVEMENT OF THE WORK PLATFORM, PUSH
IN THE EMERGENCY STOP BUTTON AFTER YOU
HAVE ARRIVED AT YOUR DESIRED LOCATION
OR ELEVATION.
4. Pull out the Eme rgency Stop Button.
5. Turn key switch to “PLATFORM” position.
6. To Raise or Lower the Platform:
1- Ensure the emergency stop button is pulled
out. Select “LIFT” position with the Lift/Off/
Drive Toggle Switch.
2- Earlier models: Depress and hold the
Enable push-button (if equipped), then lift
the controller lock ring.
Later models: Activate and hold the Enable
trigger switch (by squeezing it towards the
joystick)
3- Push the controller handle forward to raise
or backwards to lower until a desired height
is reached.
4- Return the joystick to the neutral center
position to stop. Release the Enable switch
(if equipped).
Note: Platform lowering is not proportional.
Note
If the tilt alarm sounds and the platform does not, or
only partially raises, immediately lower the platform
and ensure that the machine is on a compacted
LEVEL surface.
Note
A lowering warning system is standard on (CE) Models
This system automatically stops the lowering function
before reaching the fully lowered position and sounds
an alarm. After the operator has checked that no
person is near the scissors, the lowering function can
be reactivated. These machines also have scissor
guards.
7. To Drive Forward or Reverse:
1- Ensure the emergency stop button is pulled
out. Select “DRIVE” position with the Lift/
Off/Drive Toggle Switch.
2- Earlier models: Depress and hold the
Enable push-button (if equipped), then lift
the controller lock ring.
Later models: Activate and hold the Enable
trigger switch (by squeezing it towards the
joystick)
3- Push or pull the controller handle forward or
backward to the desired speed and direction
of platform travel.
4- Return the joystick to the neutral center
position to stop. Release the Enable switch
(if equipped).
Warning
IF THE MACHINE DOES NOT DRIVE WHEN
ELEVATED, DISENGAGE THE DRIVE
CONTROLLER. LOWER THE PLATFORM
IMMEDIATELY. ENSURE THE MACHINE IS
BEING OPERATED ON A COMPACTED, FIRM
LEVEL SURFACE OR THE TILT SENSOR WILL
DISABLE SOME OR ALL FUNCTIONS.
8. To Sound the Horn: Depress the horn push-
button located on the side of the operator’s
platform control box.
9. To Steer: Select “DRIVE” position with the Lift/
Off/Drive Toggle Switch. If equipped, activate
and hold the Enable switch (by squeezing the
trigger towards the joystick or pressing the
control box side mounted push button), then
press the rocker on top of the controller handle
in the direction you wish to steer.
Note : Steering is not proportional.