Skyjack SJ8831 RT, Руководство по эксплуатации

Страница: 47 / 88

Rough Terrain Scissors
December 2007 Page 47
Section 3 - Operation Start Operation
3.8-2 To Raise or Lower Platform Using Base
Control Console
WARNING
Be aware of overhead obstructions or
other possible hazards around the aerial
platform when lifting.
WARNING
Do not lower the platform unless the
area below is clear of personnel and
obstructions.
1. Activate base control console (refer to
Section 3.8-1 ).
2. Insert key into off/platform/base key switch. Select
and hold off/platform/base key switch to “ ”
base position.
3. Select and hold lower/neutral/raise switch to either
“ ” raise or “ ” lower position. Release switch
to stop.
Lowering Warning System - A lowering warning
system automatically stops the lowering function
before reaching the fully retracted position and
sounds the alarm. After the operator has released
the down controls and taken time to check that no
person or obstructions are near the scissors, the
lowering function can be reactivated.
3.8-3 To Activate Platform Control Console
1. Turn main power disconnect switch to “ ” on
position.
2. On engine control console, select off/on/start
switch to “ ” on position.
3. On base control console, pull out “ ” emergency
stop button.
4. Insert key into off/platform/base key switch. Select
off/platform/base key switch to “ ” platform
position.
WARNING
Ensure that you maintain three points of
contact when using the ladder to mount/
dismount platform.
5. Use the ladder of aerial platform to access
platform.
6. Close the gate.
7. On platform control console, insert key into off/lift/
drive key switch and select “ ” lift position.
8. Pull out “ ” emergency stop button. A beeping
sound should be audible and light should come
on.
WARNING
If beeping sound is not audible and light
does not come on, aerial platform must
be tagged and placed out of service.
9. Select low/high throttle switch to “ ” low throttle
position.
CAUTION
Do not start the engine in the high throttle
position.
10. If diesel engine is cold, depress and hold glow
plug pushbutton for 15 to 20 seconds.
11. Depress and hold “ ” engine start pushbutton
to start the engine.