SKY-HERO Little Six, Быстрый старт, Страница: 7 / 31

7
TOOLS REQUIRED FOR ASSEMBLY
ADDITIONAL EQUIPMENT THAT YOU WILL NEED
(to fly aircraft)
Radio Transmitter* (and compatible 6 channel or more receiver)
Lipo Battery 4S* ( Capacity of 3000mAH / 65c or higher recommended)
(*) PRODUCT AVALABLE ON WWW.SKY-HERO.COM
PLANNING YOUR INSTALLATION
Before starting to assemble your SKY-HERO aircraft, it is important to plan your build. You should check that you have
all of the parts and components that you will need. You should also think about what accessories you might want to add
to the aircraft and also where on the frame you will locate them. For example you might want to add a Camera Gimbal
or navigation lights. You need to consider how any accessories that you might add, could affect the Centre of Gravity as
well as things like which route the wiring will take. Some wires might need to be shortened whilst others might need to
be extended. One tip is (prior to starting the assembly) lay out your electronics, motors, wiring, etc against the frame and
check that there is space for everything.
If you will locate the ESCs in the arms of the Aircraft as recommended, it may be necessary to adjust the length of their
cables to avoid excessive cabling in the main body or the tubes of the frame. Remember that if you will fold the arms away
after flying, you may need some extra cable to allow for the bending of the arms.
The setup of the NAZA flight controller is not covered within this manual as full instructions can be found on the DJI
website
(www.dji.com) under NAZA-M (http://www.dji.com/product/naza-m-v2). You should make sure you have access
to the manual and necessary software, in order to configure the flight controller and to carry out your pre-flight checks.
2 mm hex wrench
2.5 mm hex wrench
3 mm hex wrench
7 mm wrench
A reamer tool (optional)
Double-sided adhesive tape
Blue threadlock (Loctite)
12 mm Heat Shrink tubing