TAB TEXT HERE
TAB TEXT HERE
TAB TEXT HERE
TAB TEXT HERE
TAB TEXT HERE
E N V I R O L I N K M A N U A L
REV 04/24/06
ENVIROLINK MANUAL (CONTINUED)
(continued)
To select an option:
From
Idle Mode
, Press
MENU
until the display reads
CNFG
(Configuration) and press
ENTER
.
Press
MENU
until the display reads
OUT4
(Output 4). Press
ENTER
.
Press
MENU
until you reach the option you want and press
ENTER
. (Do not select
PCT
)
Programming the Skutt KilnMaster 600 for use with the EnviroLink
OP A (Option A)
When Option A is selected Output 4 will turn on when a
ConeFire Mode
program is started. When the
program has run and the kiln has cooled to 150 °F output 4 will turn off.
When a
Ramp/Hold
program is entered it will ask whether you want the fan (or other accessory) on for
each segment you program. After you enter the hold time for each segment the display will show
FAN
along with the number of the segment you are programming. Alternately it will flash the current setting,
either
OFF
or
ON
. To change the setting toggle it with the 1 key and press
ENTER
to select that setting.
OP b (Option B)
During a
ConeFire
program Output 4 will turn on when
START
is pressed. It will then turn off at 1450 °F.
It will turn back on when the kiln is cooling and the temperature drops below 1000 °F. It will then turn
off when the kiln cools to 150 °F.
When a
Ramp/Hold
program is entered it will ask whether you want the fan (or other accessory) on for
each segment you program. After you enter the hold time for each segment the display will show
FAN
along with the number of the segment you are programming. Alternately it will flash the current setting,
either
OFF
or
ON
. To change the setting toggle it with the
1
key and press
ENTER
to select that setting.
OP C (Option C)
When Option C is selected Output 4 does not come on during any portion of a
ConeFire Mode
program.
When a
Ramp/Hold
program is entered it will ask whether you want the fan (or other accessory) on for
each segment you program. After you enter the hold time for each segment the display will show
FAN
along with the number of the segment you are programming. Alternately it will flash the current setting,
either
OFF
or
ON
. To change the setting toggle it with the 1 key and press
ENTER
to select that setting.
ALR4 (Alarm 4)
This is the factory default setting. If Output 4 is not being utilized this is the setting that should be
selected. This feature can also control an external alarm or autodialer to initiate if an Error Code is
generated or if the internal temperature of the kiln reaches the temperature programmed for the
ALARM
setting of the program. To deactivate the alarm press
ENTER
.
To select an option:
From
IDLE Mode
, Press
MENU
. You will see
CHG °
Press:
8
then
2
for Option A
8
then
3
for Option B
8
then
4
for Option C
8
then
5
for Alarm 4
1.
2.
3.
1.
2.
