sks 300091, Руководство по установке

Страница: 17 / 24

SKS-Kinkel Elektronik GmbH
EN
300091 Floor compact power supply
Support-Hotline: +49 (0) 2661-98088-112 - 17 - Version: 1.3
E-Mail: support@sks-kinkel.de Document art. no. 97009603
6.2
Programming using the bell buttons on the floor door station
Step Description
1
Set the DIP-Switch 2 on the Floor compact power supply to the ON position until the
„Gespräch HL / Prog.“ LED lights up.
2 Press the first bell button on the floor station.
3
For each successfully programmed floor indoor station, the
„Gespräch HL / Prog.“ LED
goes off briefly three times.
4
If additional call addresses of floor call stations are to be programmed, repeat steps 2 and
3. Wait 2 seconds until you press the next bell button on the floor door station
5
If all floor indoor stations have been programmed into the floor compact power supply, set
the DIP-Switch 2 on the floor compact power supply to the OFF position until the
„Gespräch HL / Prog.“ LED turns off.
7 Deleting floor indoor stations
You can only delete single floor indoor stations using the light button on the floor indoor station. If the floor compact
power supply is in programming mode, you cannot call from the main line to the floor line. To delete, proceed as
described in the table below.
Step Description
1
Set the DIP-Switch 2 on the Floor compact power supply to the ON position until the
„Gespräch HL / Prog.“ LED lights up.
2 Press the light button on the floor indoor station delete this floor indoor station.
3
For each successfully deleted floor indoor station, the
„Gespräch HL / Prog.“ LED goes off
briefly and the floor indoor station rings.
4
If all floor indoor stations have been programmed into the floor compact power supply, Set
the DIP-Switch 2 on the floor compact power supply to the OFF position until the
„Gespräch HL / Prog.“ LED turns off.
8 Deleting all floor indoor stations
You can delete all programmed indoor station with the DIP-Switch 3 on the floor compact supply. If the floor compact
power supply is in programming mode, you cannot call from the main line to the floor line. To delete, proceed as
described in the table below.
Arbeitsschritt Beschreibung
1
Set the DIP-Switch 2 on the Floor compact power supply to the ON position until the
„Gespräch HL / Prog.“ LED lights up.
2 Set the DIP-Switch 3 on the Floor compact power supply also to the ON position
3
During deletion the
„Gespräch HL / Prog.“ LED will blink. Once deleted, the „Gespräch HL
/ Prog.“ and “Betrieb / Power” LED will flash.
4
After 4 seconds set the DIP-Switch 2 and 3 on the floor compact power supply to the OFF
position until the
„Gespräch HL / Prog.“ LED turns off.