sks 300091, Руководство по установке

Страница: 16 / 24

SKS-Kinkel Elektronik GmbH
EN
300091 Floor compact power supply
Support-Hotline: +49 (0) 2661-98088-112 - 16 - Version: 1.3
E-Mail: support@sks-kinkel.de Document art. no. 97009603
5 DIP-Switch
DIP- switch position Operation mode
Normal operation
Door opening time. If the DIP switch is set to ON, the door release time is 2
seconds. If the DIP switch is set to OFF, the door opening time is 5 seconds.
Programming mode for floor controller. If the DIP switch is set to ON, the
floor controller is in programming mode. To exit the programming mode, the
DIP switch must be set to OFF.
Delete all call addresses.
If DIP switches 2 and 3 are set to „ON“, all stored
calls addresses are deleted. Deletion time is 4 seconds. After this delete
period DIP switches 2 and 3 have to be reset to the “OFF” position. More
information in section 8.
Languages of the busy announcement . If the DIP switch 4 is set to ON,
only an English busy announcement is played. If DIP switch 4 is set to OFF, a
German and English busy announcement is played back.
6 Programming floor intercoms
After you have completed the DIP-switch settings on the floor compact power supply, begin programming the call
addresses of the floor indoor stations. When the floor compact power supply is in programming mode, calls cannot
be made from the main line to the floor line. Programming can be done two ways. The two tables below show the
programming process.
6.1
Programming using “S”-Button at the floor indoor station
Step Description
1
Set the DIP-Switch 2 on the floor compact power supply to the ON position until the
„Gespräch HL / Prog.“ LED lights up.
2
Check the DIP-switch settings for the call address for the floor indoor station and press the
S button on the floor indoor station.
3
For each successfully programmed floor indoor station, the
„Gespräch HL / Prog.“ LED
goes off briefly three times and the floor indoor station rings.
4
If additional call addresses of floor call stations are to be programmed, repeat steps 2 and
3.
5
If all floor indoor stations have been programmed into the floor compact power supply, Set
the DIP-Switch 2 on the floor compact power supply to the OFF position until the
„Gespräch HL / Prog.“ LED turns off.