GENERAL FUNCTIONS AND CONTROLS (Cont.)
UDJ-1000 Instruction Manual Page
7
24. RELOOP BUTTON
-
If a SEAMLESS LOOP has been made, but the player is not actively in seamless loop
mode, pressing the reloop button will instantly reactivate the seamless loop mode. To exit loop, press the out
button. LOOP and RELOOP will appear in the VFD display when the RELOOP function is available.
25. OUT BUTTON -
This button is used to set the ending point of a loop. A loop is started by pressing the IN button,
pressing the OUT button set the loop ending point. The loop will continue to play until the OUT button is
pressed once again.
26.
IN BUTTON -
This function allows you to set a CUE POINT without music interruption. This button also sets
the starting point of a seamless loop.
27. EFFECTS AND HOLD BUTTON
HOLD BUTTON -
This button allows you to set and lock any new parameters you set to the effects. This button
will glow when the hold function is activated. If the hold function is not selected any changes to the effect
parameters will be momentary.
PARAMETER TIME BUTTON
- This button is used to adjust the parameter time value. You can also push the
TIME knob, LED on, and turn the JOG WHEEL to adjust the parameter time value.
1. If the hold function is not selected any changes to the effect parameters will be momentary.
2. During hold function is selected the auto beat sync will be turned off.
ECHO EFFECT
-
This button is used to activate and deactivate the echo effect. The echo effect adds an echo
to your output signal.
FLANGER EFFECT
-
This button is used to activate and deactivate the flanger effect. The flanger effect
distorts the output signal and creates an effect similar to the frequency phasing in and out of each other.
FILTER EFFECT
-
This button is used to activate and deactivate the filter effect. The filter effect tweaks the
original sound to add different tonal definition.
PARAMETER RATIO BUTTON -
This button is used to adjust the parameter ratio value. You can also push the
RATIO knob, LED on, and turn the JOG WHEEL to adjust the parameter ratio value.
AUTO LOOP BUTTON
-
Press this button to activate AUTO LOOP function. Press IN button, and OUT point
will be found automatically according to the BPM value.
28. MIDI A/B -
Under the MIDI mode, press this button to switch PLAYER A/B.
29. SGL/CTN BUTTON -
This function allows you to choose between single track play or continuous track play (all
tracks in order). This function also operates in RELAY mode. With this button you can also switch auto cue on
and off, by pressing it for at least 1 sec.
30. TIME BUTTON -
The button will switch the time value described in the TIME METER between ELAPSED
playing time, TRACK Remaining time.
31.
-
Use this button to select FX SYNC or LOOP SET.
FX SYNC -
This is used to select the delay time of an effect to the beat of music. The beat delay ratios are 1/4,
1/2, 3/4, 1/1, 2/1, and 4/1. To turn off auto beat sync press
button for 1sec.
LOOP SET
-
When the loop set function is activated, select the beat bar of 1/2, 1, 2, 4, 8, 16 (1 bar = 4 beat)
at which you would like to start your desired loop.
