13
SKOPE B1200-2/B1200G-2
Servicing
User Manual
Lighting
This chiller is designed for use with LED tubes and is not compatible with
fluorescent tubes.
Interior Light
The cabinet interior is lit by two 19 Watt T8 LED tubes (Ø26mm x 1200mm),
which can be replaced without moving shelves or removing product.
To replace the cabinet interior light
IMPORTANT
DO NOT
use fluorescent tubes.
1. Remove the front panel and isolate the chiller from the mains power supply
(see previous page).
2. Remove the diffuser by squeezing it until it is released from the aluminium
housing, and then push the diffuser out of the way.
3. Rotate the LED tube until
the pins on the ends of the
tube align with the slots,
then slide it out.
4. Fit a new LED tube.
Note:
the pointer at each
end of the tube should be
set to the “0” position.
5. Refit the diffuser by slipping the back section into the housing, then
squeezing and snapping the front section of the diffuser into place as you
work down the length of the light.
Pins
Lamp Holder
LED Tube
(partially removed)
