■
Reminder: Remember your mobile
- Switch on/off reminder for a connected tel-
ephone when the ignition is switched off and the ignition key is removed (or the
ignition is turned off and the driver's door opened in the case of vehicles with
the KESSY system)
■
Select ring tone
- Selects the ring tone if the connected phone does not sup-
port the in-band ringing function
1)
■
Show pictures for contacts
- Switch on/off the display of the image assigned to
the contact in the mobile phone
2)
Connect the device with the mobile phone
Introduction
This chapter contains information on the following subjects:
Conditions for pairing
37
Connect device with your mobile phone
38
Pair the mobile phone with the device
38
Connection with another paired mobile phone
39
Switching on / off Bluetooth
®
profile
39
Clear mobile phone from the list of paired devices
40
Disconnection
40
First and foremost, pay attention to the safety instructions
» page 4
,
Important
notes
.
The device is shown in the telephone to be connected as SKODA_BT_... .
... is replaced with the last four symbols of the VIN vehicle identification number
of your vehicle.
You can change the name of the device
» page 20
.
WARNING
The unit may require confirmation of certain features in the mobile phone
when pairing. Do not carry out the pairing process while driving - there is dan-
ger of accidents!
Note
■
The maximum number of phones that can be registered is 20. Upon reaching
the maximum number and by pairing a new phone, the least recently used paired
phone will automatically be deleted.
■
In some countries, the use of the Bluetooth
®
function with phones can be re-
stricted. Further information can be obtained from local authorities.
■
The range of the Bluetooth
®
connection is restricted to the vehicle interior. This
depends on local conditions and interference with other devices.
■
When pairing from the mobile phone, follow the instructions in the owner's
manual of the mobile phone.
Conditions for pairing
First read and observe the introductory information and safety warn-
ings on page 37.
To connect a phone with the device, the two devices must be paired.
Prerequisites for successful pairing:
The ignition is switched on.
The Bluetooth
®
function of the device
» page 20
for the mobile phone is
switched on.
The visibility of the mobile phone is switched on
» page 20
.
The visibility of the mobile phone is switched on.
The mobile phone to be connected should not have an active connection to
another mobile phone.
The pairing can be initiated from the device as well as from the mobile phone.
1)
The in-band ringing function makes it possible to use the ring tone of your phone as the ring tone.
2)
This function is only supported by some phones.
37
Communication
