Page 42 of 68
Page 43 of 68
SKIPPER
Electronics AS
Edition:
2021.11.04
SKIPPER
Electronics AS
Edition:
2021.11.04
ESN200 Operation and Installation Manual
ESN200 Operation and Installation Manual
Chapter: CONFIG software setup
Chapter: CONFIG software setup
It is also possible to find which software is loaded in the Display on display.
Press “Config”, “Display setup”, “Screen setup”
Find software version loaded on the JB70E2 unit
Press “Config”, “JB70 setup”
Printing
Printers
EPSON LQ350, OKI ML1190eco or OKI ML280 can be connected to the JB70 USB connector for continu
-
ous/page printing.
EPSON TM-T20III Text printer (USB version) is also available to print. Printing Date, Time, FWD AFT and
Position.
A pay option is also available to print out GPS status information from up to 2 GPS’s connected to NMEA
inputs. The text printer allows you to select how often the printout should
be activated.
OEM or branded printers is not tested and may not be supported
An information on the screen can be changed to activate printing
(from software version 1.0.6)
Setup print button in Runtime Screen
In runtime setup, activate one of the information buttons to Printing.
This will show ‘On’ or ‘Off’
Setup printer type in “Print Setup” menu
The printer is enabled and type selected in “Config”, “Print setup”.
Select Printing “ON”, select the correct printer and channel.
Printers: EPSON350, OKI ML280, OKI ML 1190eco, LAN – using service software to print
from a local printer,None
Print Echogram and or marks: (Echo/marks(text)/both)
Print channel: Which channel to print (1/2/primary/both)
The printer prints a full page per channel every 15-17 minutes. When turned off, the printer will
finish printing the current file before stopping, with slower printers this can take up to 5 minutes.
With slow printers we recomend only to print both echograms or 1 channel, not both echograms
and both marks files.
To test the printer, turn printing on, a start page will print, then place the system in simulator mode,
using the source-’from file’ option in diagnostic setup. Then activate the printer, and wait for the
printer to print (17 mins).
First Page
Prev Page
Next Page
Last Page
First Page
Last Page
Prev Page
Next Page
