7
240V
humid
Install the unit indoor.
-The unit is designed for indoor use only.
-Using the unit outdoor can damage the unit
and may cause low performance.
Make sure to install the unit on solid and
even surfaces.
- Installation on unstable surfaces can cause
vibration, leaks and noise.
- If the surface is not even, place a solid board
underneath the unit.
- Lock the wheels so that the unit is fixed to the
surface.
Avoid placing the unit in areas which
heat or flammable gases are frequently
produced.
- Coal briquettes or flammable gases can cause
the change of colour of the unit’s exterior or
shorten the life of the unit as it can get rusty.
Please install the unit in a good ventilated
place.
-Will make the unit run efficiently.
-If you cannot install in a good ventilated place,
installing an exhaust fan is a good idea.
Do not place the unit in areas where water
can be splashed on to the unit, there are
a lot of dusts, or highly humid.
-If the unit is installed where it is humid or
there is contact with water, the unit can get
rusty and it can also cause a short circuit.
-Keep the unit out of direct sunlight or any
heating object.
Avoid placing the unit where there is
direct sunlight or near any equipment
such electric or petrol stove which produce
heat.
Please place the unit in room temperatures
between 10°C to 35°C for optimal
performance.
-Room temperatures below 10°C will make it
harder to defrost parts inside the unit.
-Room temperature above 35°C will make the
unit work harder to maintain temperature
thus shortening its lifespan and core parts
breaking down.
Check the rated voltage of the area
before plugging in the unit.
- This unit is for 240V only.
- This unit cannot be used in the areas of 110V.
(Using a transformer to raise the voltage will
cause breakdown of the unit.)
Installation
5cm
please check!
Please plug in the unit 2 to 3 minutes after
installing the unit into a 240V socket.
