SKILTEC DUETTE VERTIGLIDE SIDE STACK DESIGN POWERVIEW MOTORISATION 9G-B, Руководство по эксплуатации товара

Страница: 20 / 40

PRODUCT INFORMATION MANUAL
SECTION: 9G-B DUETTE
®
VERTIGLIDE
™
SIDE STACK DESIGN
POWERVIEW
®
MOTORISATION
ISSUE DATE: NOVEMBER 2017 ORIGINATOR: SKILTEC
REPLACES ISSUE DATE: APPROVED BY: D.ALTIPARMAKOVA PAGE 20
■
Position the cords.
➤
From the outside of the end plate, place the washer on the end of one cord behind the
slot in the middle of the end plate, so that the cord fits into the slot. Pull the cord taut to
seat the washer.
➤
Cut the knot from the end of the other cord and tie the cord to the cord tensioner using a
square knot. (There are two cord tensioners in the headrail; one is a spare.) Trim the end
of the cord to about 13mm.
➤
Loop the cord from the tensioner around the “T” near the front of the end plate. The top
of the loop must be the cord from the cord tensioner. Be sure the cord is not twisted.
Washer Slot
Loop Around
the “T”
Top from
Tensioner
Bottom from
Moving Rail