4
Do not handle charger, including the charger
plug and charger terminals with wet hands.
Use of an attachment not recommended or
sold by the battery-charger manufacturer may
result in a risk of fire, electric shock, or injury
to persons.
Recharge only with the charger specified by
the manufacturer. A charger that is suitable
for one type of battery pack may create a risk
of fire when used with another battery pack.
Do not abuse the cord or charger. Never use
the cord to carry the charger. Do not pull the
charger cord to disconnect the plug from a
receptacle. Damage to the cord or charger
could occur and create an electric shock
hazard. Replace damaged cords immediately.
Make sure that the cord is located so that it
will not be stepped on, tripped over, come in
contact with sharp edges or moving parts, or
otherwise be subjected to damage or stress.
This will reduce the risk of accidental falls,
which could cause injury and damage to the
cord, which could then result in electric shock.
Keep the cord and charger from heat to
prevent damage to housing or internal parts.
Do not allow gasoline, oils, petroleum-based
products, etc. to come in contact with plastic
parts. These materials contain chemicals that
can damage, weaken, or destroy plastic.
Do not operate the charger with a damaged
cord or plug, which could cause shorting and
electric shock. If damaged, have the charger
repaired or replaced by an authorized service
technician at a SKILSAW Service Center.
Do not operate the charger if it has received
a sharp blow, been dropped, or has otherwise
been damaged in any way. Take it to an
authorized service technician for an electrical
check to determine if the charger is in good
working order.
Do not disassemble the charger. Take it to an
authorized service technician when service or
repair is required. Incorrect reassembly may
result in a risk of electric shock or fire.
Unplug the charger from the electrical outlet
before attempting any maintenance or
cleaning to reduce the risk of electric shock.
Disconnect charger from the power supply
when not in use. This will reduce the risk of
electric shock or damage to the charger if
metal items should fall into the opening. It
will also help prevent damage to the charger
during a power surge.
Risk of electric shock. Do not touch the
uninsulated portion of output connector or
uninsulated battery terminal.
Save these instructions. Refer to them
frequently and use them to instruct others who
may use this tool. If you lend this tool to some
one else, also lend these instructions to them
to prevent misuse of the product and possible
injury.
WARNING
When using electric
appliances, basic
precautions should always be followed,
including the following.
To reduce the risk of injury, close supervision
is necessary when an appliance is used near
children.
Only use attachments recommended or sold
by manufacturer.
Do not use outdoors.
For a portable appliance – To reduce the risk
of electrical shock, do not put charger in water
or other liquid. Do not place or store appliance
where or can fall or be pulled into a tub or sink.
FCC Caution
1. This device complies with Part 15 of the
FCC Rules. Operation is subject to the
following two conditions:
(1) This device may not cause harmful
interference.
(2) This device must accept any interference
received, including interference that may
cause undesired operation.
2. Changes or modifications not expressly
approved by the party responsible for
compliance could void the user’s authority
to operate the equipment.
NOTE: This equipment has been tested and
found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the
FCC Rules. These limits are designed to
provide reasonable protection against harmful
interference in a residential installation.
This equipment generates, uses, and can
radiate radio frequency energy and, if not
installed and used in accordance with the
instructions, may cause harmful interference
to radio communications. However, there is
no guarantee that interference will not occur
in a particular installation. If this equipment
does cause harmful interference to radio or
television reception, which can be determined
by turning the equipment off and on, the user
is encouraged to try to correct the interference
by one or more of the following measures: