skilsaw SPT99T, Инструкция по эксплуатации и безопасности

Страница: 30 / 152

-30-
ADJUSTING THE TABLE INSERT
The table insert slot contains four (4) adjustment
screws for adjusting the height of the table insert
(Fig . 36) . Place the insert onto the table . Place a
straight edge (such as the metal ruler from a com-
bination square) across the table top and insert
top . If adjustment is necessary, use a 4mm Flat
Head Screwdriver to rotate each set screw up or
down . The insert should be slightly below the
table at the front and slightly above the table at the
back .
Table Insert
Screws
Adjustments
7 . Insert folded paper between riving knife and
fence .
a. Hold the riving knife and paper firmly
against the fence (Fig . 35) .
b . Lightly tighten the clamp screws .
c . Remove the paper and move the fence
away from blade .
d . Slowly turn the set screw 1 (for left and
right adjustment) and set screw 2 (for front
and rear adjustment) while watching the
riving knife tilt until it is in line with the
blade .
e . Recheck squareness of riving knife to ta-
ble by sliding the fence against blade . Re-
adjust if necessary .
8 . After completing adjustments:
a . Lightly tighten the hex nut (hold the set
screw in position with a screwdriver while
tightening nut) .
b . Fully tighten clamp screws with an Allen
wrench . Then fully tighten the hex nut .
Clamp
Screw
Fence
Riving
Knife
Paper
NOTE: Check that the riving knife stays in line
with the blade when the blade is tilted at any
angle . Replace the Barrier Guard Assembly and
Anti-Kickback Device before making cuts .
FIG. 36
FIG. 35